96 Honda hatch For sale in Arkansas 1500 firm
#1
96 Honda hatch For sale in Arkansas 1500 firm
1996 Honda Civic hatch back.
D16y7 SOHC motor w/approx 120K. 5 speed with a stage 3 clutch. Possibly needs a slave cylinder. It acts kinda funny sometimes. Motor has no preformance parts added besides clutch.
The syuspension consist of the following.
Upper Skunk2 arms, coil overs on all 4 corners, front and rear sway bars car never came with a front from the factory. Ther rear also has upper and lower tie bars from Skunk2 . This supension is tight. The car pulls a 3 wheel pulling into my driveway.
The exterior of the car is pretty good. Hood and wing have been primered, for some reason not sure why . Hood is clean except 1 small spot where I installed a hood bolt and it was a little long. The rest of the body is fairly clean. It has a few small dings hee and there. The body line was shaved on the passenger side, but not the driver side. Probably from loosing intrest. The driver side has some red rattle can primer where someone started to prep the body line, but never finished. Car needs a drivers mirror, which I am trying to find now without buying a new one.
The interior is as follows.
In the theme of weight reduction this car was cleaned out. No interior was left inside with the exception of 2 door panels, most of the dash, and 2 bucket seats. I have found quite a bit of the pieces to go back in it, just have not been able to pick them up yet. I have sprayed the trunk area with undercoating to minimize the road noise.
I have driven this car damn near everyday to work. About 30 mile round trip. besides it is a bit stiff from the suspension. It handles and performs very well. It gets around 30mpg on the last 2 tanks of fuel. I just changed the oil and filter.
I have found truck I want , and need to try and move this fairly quickly. I am asking 1500.00 firm. I have a few pics posted below. The interior pic is not updated as I have added the pass door panel back on and some more dash parts and door sills.
PM me if interested or to make an offer.
Thanks
Ricky@3rdshiftkustoms.com
D16y7 SOHC motor w/approx 120K. 5 speed with a stage 3 clutch. Possibly needs a slave cylinder. It acts kinda funny sometimes. Motor has no preformance parts added besides clutch.
The syuspension consist of the following.
Upper Skunk2 arms, coil overs on all 4 corners, front and rear sway bars car never came with a front from the factory. Ther rear also has upper and lower tie bars from Skunk2 . This supension is tight. The car pulls a 3 wheel pulling into my driveway.
The exterior of the car is pretty good. Hood and wing have been primered, for some reason not sure why . Hood is clean except 1 small spot where I installed a hood bolt and it was a little long. The rest of the body is fairly clean. It has a few small dings hee and there. The body line was shaved on the passenger side, but not the driver side. Probably from loosing intrest. The driver side has some red rattle can primer where someone started to prep the body line, but never finished. Car needs a drivers mirror, which I am trying to find now without buying a new one.
The interior is as follows.
In the theme of weight reduction this car was cleaned out. No interior was left inside with the exception of 2 door panels, most of the dash, and 2 bucket seats. I have found quite a bit of the pieces to go back in it, just have not been able to pick them up yet. I have sprayed the trunk area with undercoating to minimize the road noise.
I have driven this car damn near everyday to work. About 30 mile round trip. besides it is a bit stiff from the suspension. It handles and performs very well. It gets around 30mpg on the last 2 tanks of fuel. I just changed the oil and filter.
I have found truck I want , and need to try and move this fairly quickly. I am asking 1500.00 firm. I have a few pics posted below. The interior pic is not updated as I have added the pass door panel back on and some more dash parts and door sills.
PM me if interested or to make an offer.
Thanks
Ricky@3rdshiftkustoms.com
#5
RE: 96 Honda hatch For sale in Arkansas 1800 OBO.
You can e-mail me
Ricky@3rdshiftkustoms.com if you have ?'s or post them here. I will check back as often as I can. I drive this car daily and have yet to have any problems.
Ricky@3rdshiftkustoms.com if you have ?'s or post them here. I will check back as often as I can. I drive this car daily and have yet to have any problems.
#6
RE: 96 Honda hatch For sale in Arkansas 1800 OBO.
This is a very reliable, no oil leaking at all, starts everytime drivabe civic. I got a few e-mails wanting to know if it even runs for this price. I drive it everyday to and from work.
E-mail me
Ricky@3rdshiftkustoms.com
E-mail me
Ricky@3rdshiftkustoms.com
#8
RE: 96 Honda hatch For sale in Arkansas 1800 OBO.
The car is located in Van Buren Arkansas. I am about 1 hours south of Fayetteville AR. If you do not know where that is I am on the west side of Arkansas 1 mile north of I-40 almost exactly where it crosses the border into oklahoma.