HID temps???
#21
RE: HID temps???
ORIGINAL: ic892003
i have 8k, pretty nice and it has ok visibility, jsut so u know the higher u go in temperature the worse the visibility gets
i have 8k, pretty nice and it has ok visibility, jsut so u know the higher u go in temperature the worse the visibility gets
I think I'll just get some non-bi-xenon for the teg since I'm cheap. But I won't even have fogs to flash at people, maybe I'll just flash my low beams off and on [8D]
#22
RE: HID temps???
[Reply to Message]
most after market HIDs is a horible idea to flash the headlights on cause thier ignitors will burn out....
OEM HIDS are the only ones i would ever flash people with cause they are just made SO MUCH BETER... but they also cost alot more.
#23
RE: HID temps???
Haha gotcha. Good thing I was joking
Sorry for posting about a teg, but do you know if tegs have the same problem of HID bulbs not fitting in the projector housings? Because my stock housing are NASTY (I sanded them and cleaned them best I could) but HID bulbs can't fit in projector housing in Civics, and I don't wanna waste 400 dollars trying to do it on a Teg.
Sorry for posting about a teg, but do you know if tegs have the same problem of HID bulbs not fitting in the projector housings? Because my stock housing are NASTY (I sanded them and cleaned them best I could) but HID bulbs can't fit in projector housing in Civics, and I don't wanna waste 400 dollars trying to do it on a Teg.
#24
RE: HID temps???
you saying they wont fit.... are they the right size bulb for the housings?
headlight housings are different sizes and use different bulbs,
so if you have some projectors you need to buy the HID bulbs to fit them, but like said before for projectors you do have to cut the openings just alittle bit to fit the hid bulbs in thier.... BUT as long as they are the right siz bulb it shouldnt take much cutting on the housings for them to fit...
headlight housings are different sizes and use different bulbs,
so if you have some projectors you need to buy the HID bulbs to fit them, but like said before for projectors you do have to cut the openings just alittle bit to fit the hid bulbs in thier.... BUT as long as they are the right siz bulb it shouldnt take much cutting on the housings for them to fit...
Thread
Thread Starter
Forum
Replies
Last Post
Jeremy102579
Mechanical Problems & Technical Chat
2
02-20-2011 09:08 AM
zspeedzkwy
PRIVATE For Sale / Trade Classifieds
4
01-04-2008 11:45 PM